User's Guide
Table Of Contents
- English
- Contents
- Supplier's Declaration of Conformity
- Important Safety Information
- Notice to Users (FCC)
- Notice to Users (Industry Canada)
- Software Version
- Intellectual Property and Regulatory Notices
- Computer Software Copyrights
- Radio Care
- Introduction
- Getting Started
- Radio Controls
- Status Indicators
- Channel Selections
- Calls
- Advanced Features
- Utilities
- Authorized Accessories List
- Batteries Warranty
- Limited Warranty
2.5
Attaching and Removing the Belt
Clip
Attaching the Belt Clip
Align the grooves on the clip with the grooves on the
battery and press it downwards until it clicks.
Removing the Belt Clip
1 To remove the clip, press the belt clip tab away from
the battery.
2 Slide the clip upwards and away from the radio.
2.6
Turning the Radio On
Rotate the On/Off/Volume Control knob clockwise
until it clicks.
If successful, your radio shows the following indications:
• A tone sounds.
NOTE:
If the Tones/Alerts function is disabled, there is
no tone upon powering up.
• The green LED lights up.
If your radio does not power up, check your battery. Make
sure that the battery is charged and properly attached.
Contact your dealer if your radio still does not power up.
English
20