User's Guide
Table Of Contents
- Documentation Copyrights
- Disclaimer
- Computer Software Copyrights
- Batteries, Chargers, and Audio Accessories Safety Information
- Operational Safety Guidelines
- Acoustic Safety
- FCC Licensing Information
- Supplier's Declaration of Conformity
- Class B Digital Device
- Radio Frequency Exposure Safety Standards
- Product Safety and RF Exposure Compliance.
- Notice to Users
- Introduction
- Radio Controls
- Installing the Batteries
- Charging the Battery
- Turning Your Radio On and Off
- Adjusting the Volume
- Reading the Display
- Talking and Receiving
- Basic Radio Operation
- Signal Strength and Channel Busy Indicators
- Talk Range
- Locking the Keypad
- Monitoring a Channel
- Programming Mode
- Entering Programming Mode
- Cloning Radio Settings
- Troubleshooting
Troubleshooting
25
Troubleshooting
Symptom Try This:
No Power
Recharge or replace Li-Ion battery.
Message not
transmitted
Make sure
Push to Talk
is completely pressed while
transmitting.
Recharge, replace, and/or reposition batteries.
Verify the transmit light is illuminated while speaking.
Hearing other
noises or
conversation on
a channel
Frequency may be in use.
Poor audio
quality
Bandwidth does not match. For optimal audio quality when
communicating with Series radios, the bandwidth of other
radios should be set to 12.5 kHz, if possible.
Charger light
does not come
on
Reinsert radio and/or battery.
Clean battery and/or charger contacts.
Verify that the charging pin on the transformer is inserted
correctly into the drop-in charger.
6880309S61-P.book Page 25 Wednesday, June 3, 2020 1:56 PM