User's Guide
Table Of Contents
- Documentation Copyrights
- Disclaimer
- Computer Software Copyrights
- Batteries, Chargers, and Audio Accessories Safety Information
- Operational Safety Guidelines
- Acoustic Safety
- FCC Licensing Information
- Supplier's Declaration of Conformity
- Class B Digital Device
- Radio Frequency Exposure Safety Standards
- Product Safety and RF Exposure Compliance.
- Notice to Users
- Introduction
- Radio Controls
- Installing the Batteries
- Charging the Battery
- Turning Your Radio On and Off
- Adjusting the Volume
- Reading the Display
- Talking and Receiving
- Basic Radio Operation
- Signal Strength and Channel Busy Indicators
- Talk Range
- Locking the Keypad
- Monitoring a Channel
- Programming Mode
- Entering Programming Mode
- Cloning Radio Settings
- Troubleshooting
Programming Mode
23
Programming Mode
Programming mode allows you to perform the following function on your radio:
• Cloning
Note: To talk with someone on your two-way radio, the channel, frequency, and interference eliminator
code must be the same on both radios, which will depend on the store profile that has been
preprogrammed on the radio.
Entering Programming Mode
Press and hold
Push to Talk
and for 7 seconds while turning the radio on. The
radio beeps and displays .
Note: If you press and release the
Push to Talk
button when programming, you will exit Programming
Mode.
6880309S61-P.book Page 23 Wednesday, June 3, 2020 1:56 PM