User's Guide
Table Of Contents
- Documentation Copyrights
- Disclaimer
- Computer Software Copyrights
- Batteries, Chargers, and Audio Accessories Safety Information
- Operational Safety Guidelines
- Acoustic Safety
- FCC Licensing Information
- Supplier's Declaration of Conformity
- Radio Frequency Exposure Safety Standards
- Product Safety and RF Exposure Compliance.
- Notice to Users
- Introduction
- Radio Controls
- Getting Started
- Installing the Batteries
- Installing the Swivel Belt Holster
- Charging the Battery
- Turning Your Radio On and Off
- Adjusting the Volume
- Reading the Display
- Talking and Receiving
- Basic Radio Operation
- Signal Strength and Channel Busy Indicators
- Talk Range
- Locking the Keypad
- Monitoring a Channel
- Scanning (CLS1410 Only)
- Customer Programming Mode
- Factory Default Settings
- Entering Advanced Configuration Mode
- Feature Summary Chart
- Features
- Backlight
- Call Tones
- Channels
- Cloning Mode
- Frequencies
- Bandwidth Range
- Codes, Interference Eliminator Codes (CTCSS/DPL)
- Keypad Beep (or Keypad Tone)
- Keypad Lock
- Low Battery Alert - Shutdown
- Maximum Channels
- Microphone Gain Level
- Monitor
- Nuisance Ch Delete
- Scan Advanced
- Reset to Factory Defaults (2)
- Reverse Burst
- Scan
- Cloning Radio Settings
- Advanced Features
- Troubleshooting
- Use and Care
- Frequencies and Bandwidths
- Accessories
- Batteries
- Audio Accessories
- Carry Accessories
- Chargers
- Programming Accessories
- Limited Warranty for Motorola Solutions Personal Communications Products Purchased in the United States and Canada
- Warranty
- I. What This Warranty Covers
- II. Products and Accessories
- III. Products and Accessories (Exclusions)
- IV. Software
- V. Software (Exclusion
- VI. Who is Covered?
- VII. How to Obtain Warranty Service Or Other Information?
- VIII. Software Copyright Notice
- IX. Software Copyright Notice
- X. Patent Notice
- XI. Export Law Assurances
- _Series Programming Quick Reference
Batteries, Chargers, and Audio Accesso-
3
Batteries, Chargers, and Audio Accessories Safety Information
This document contains important safety and operating instructions. Read these
instructions carefully and save them for future reference. Before using the battery
charger, read all the instructions and cautionary markings on:
• the charger
• the battery
• the radio attached with battery
1. To reduce risk of injury, charge only the rechargeable Motorola Solutions-
authorized batteries. Charging the other batteries may cause explosion, personal
injury, and damage.
2. Use of accessories not recommended by Motorola Solutions may result in fire,
electric shock, or injury.
3. To reduce damage to the electric plug and cord, pull by plug rather than the cord
when disconnecting the charger.
4. An extension cord should not be used unless necessary. Use of an improper
extension cord may result in fire and electric shock. If an extension cord must be
used, make sure that the cord size is 18 AWG for lengths up to 2.0 m (6.5 feet),
and 16 AWG for lengths up to 3.0 m (9.8 feet).
5. Do not operate the charger if it has been broken or damaged in any way. Take it
to any qualified Motorola Solutions service representatives.
6. Do not disassemble the charger; it is not repairable and replacement parts are
not available. Disassembly of the charger may result in risk of electrical shock or
6864110W15_.book Page 3 Thursday, May 28, 2020 2:17 PM