User's Guide
Table Of Contents
- Documentation Copyrights
- Disclaimer
- Computer Software Copyrights
- Batteries, Chargers, and Audio Accessories Safety Information
- Operational Safety Guidelines
- Acoustic Safety
- FCC Licensing Information
- Supplier's Declaration of Conformity
- Radio Frequency Exposure Safety Standards
- Product Safety and RF Exposure Compliance.
- Notice to Users
- Introduction
- Radio Controls
- Getting Started
- Installing the Batteries
- Installing the Swivel Belt Holster
- Charging the Battery
- Turning Your Radio On and Off
- Adjusting the Volume
- Reading the Display
- Talking and Receiving
- Basic Radio Operation
- Signal Strength and Channel Busy Indicators
- Talk Range
- Locking the Keypad
- Monitoring a Channel
- Scanning (CLS1410 Only)
- Customer Programming Mode
- Factory Default Settings
- Entering Advanced Configuration Mode
- Feature Summary Chart
- Features
- Backlight
- Call Tones
- Channels
- Cloning Mode
- Frequencies
- Bandwidth Range
- Codes, Interference Eliminator Codes (CTCSS/DPL)
- Keypad Beep (or Keypad Tone)
- Keypad Lock
- Low Battery Alert - Shutdown
- Maximum Channels
- Microphone Gain Level
- Monitor
- Nuisance Ch Delete
- Scan Advanced
- Reset to Factory Defaults (2)
- Reverse Burst
- Scan
- Cloning Radio Settings
- Advanced Features
- Troubleshooting
- Use and Care
- Frequencies and Bandwidths
- Accessories
- Batteries
- Audio Accessories
- Carry Accessories
- Chargers
- Programming Accessories
- Limited Warranty for Motorola Solutions Personal Communications Products Purchased in the United States and Canada
- Warranty
- I. What This Warranty Covers
- II. Products and Accessories
- III. Products and Accessories (Exclusions)
- IV. Software
- V. Software (Exclusion
- VI. Who is Covered?
- VII. How to Obtain Warranty Service Or Other Information?
- VIII. Software Copyright Notice
- IX. Software Copyright Notice
- X. Patent Notice
- XI. Export Law Assurances
- _Series Programming Quick Reference
Customer Programming Mode
30
Note: See page 51 for information on frequencies for communicating with other business
radios.
Programming the Interference Eliminator Code
The interference eliminator code helps minimize interference by providing code
combinations that filter out static, noise, and unwanted messages.
1. In Advanced Configuration mode, press S until k displays
and the code number blinks.
2. Press
[or ] to select the code (see page 54).
3. Press and hold
Push to Talk
to exit, or press S to continue
programming.
Programming the Available Channels (CLS1410 only)
If you need fewer channels, you can reduce the number of available channels.
1. In Advanced Configuration mode, press S until = displays and
the channel number blinks.
2. Press
[or ] to select the number of channels you want available.
3. Press and hold
Push to Talk
to exit, or press S to continue
programming.
Note:
The radio retains settings for channels made unavailable.
6864110W15_.book Page 30 Thursday, May 28, 2020 2:17 PM