User's Guide
Table Of Contents
- Documentation Copyrights
- Disclaimer
- Computer Software Copyrights
- Batteries, Chargers, and Audio Accessories Safety Information
- Operational Safety Guidelines
- Acoustic Safety
- FCC Licensing Information
- Supplier's Declaration of Conformity
- Class B Digital Device
- Radio Frequency Exposure Safety Standards
- Product Safety and RF Exposure Compliance.
- Notice to Users
- Introduction
- Radio Controls
- Getting Started
- Installing the Batteries
- Installing the Swivel Belt Holster
- Charging the Battery
- Turning Your Radio On and Off
- Adjusting the Volume
- Reading the Display
- Talking and Receiving
- Basic Radio Operation
- Signal Strength and Channel Busy Indicators
- Talk Range
- Locking the Keypad
- Monitoring a Channel
- Scanning
- Advanced Configuration Mode
- Factory Default Settings
- Entering Advanced Configuration Mode
- Feature Summary Chart
- Features
- Backlight
- Call Tones
- Channels
- Cloning Mode
- Frequencies
- Bandwidth Range
- Codes, Interference Eliminator Codes (CTCSS/DPL)
- Keypad Beep (or Keypad Tone)
- Keypad Lock
- Low Battery Alert - Shutdown
- Maximum Channels
- Microphone Gain Level
- Monitor
- Nuisance Ch Delete
- Scan Advanced
- Reset to Factory Defaults (2)
- Reverse Burst
- Scan
- Cloning Radio Settings
- Advanced Features
- Troubleshooting
- Use and Care
- Frequencies and Bandwidths
- Accessories
- Batteries
- Audio Accessories
- Carry Accessories
- Chargers
- Programming Accessories
- Limited Warranty for Motorola Personal Communications Products Purchased in the United States and Canada
- Warranty
- I. What This Warranty Covers
- II. Products and Accessories
- III. Products and Accessories (Exclusions)
- IV. Software
- V. Software (Exclusion
- VI. Who is Covered?
- VII. How to Obtain Warranty Service Or Other Information?
- VIII. Software Copyright Notice
- IX. Software Copyright Notice
- X. Patent Notice
- XI. Export Law Assurances
- VL50 Series Programming Quick Reference
Feature Summary Chart
39
Bandwidth Range N/A N/A Model
Depend
ant
Radios Bandwidth is
fixed and non-
programmable.
Bandwidth Range
for 1W radios: UHF
461-470 Mhz.
Codes, Interference
Eliminator Codes
(CTCSS/DPL)
Yes Yes Channel
and
Model
Depend
ant
Use Advanced
Configuration Mode
for front panel radio
configuration. There
are 121 codes
available.For details
refer to Frequencies
and Codes Charts
Section.
Keypad Beep (or
Keypad Tone)
Yes No On Press - button while
turning ON radio to
enable/disable
keypad beep.
Keypad Lock Yes No UNLOC
KED
Press and hold
(MENU) button for 4
seconds to lock the
radio keypad. To
unlock, press
(MENU) button for 4
seconds.
Features Programmable
via Advanced
Configuration
Programmable
via CPS
Default Programming Tips
6881096C37_.book Page 39 Wednesday, June 3, 2020 2:04 PM