User's Guide
Table Of Contents
- Documentation Copyrights
- Disclaimer
- Computer Software Copyrights
- Batteries, Chargers, and Audio Accessories Safety Information
- Operational Safety Guidelines
- Acoustic Safety
- FCC Licensing Information
- Supplier's Declaration of Conformity
- Class B Digital Device
- Radio Frequency Exposure Safety Standards
- Product Safety and RF Exposure Compliance.
- Notice to Users
- Introduction
- Radio Controls
- Getting Started
- Installing the Batteries
- Installing the Swivel Belt Holster
- Charging the Battery
- Turning Your Radio On and Off
- Adjusting the Volume
- Reading the Display
- Talking and Receiving
- Basic Radio Operation
- Signal Strength and Channel Busy Indicators
- Talk Range
- Locking the Keypad
- Monitoring a Channel
- Scanning
- Advanced Configuration Mode
- Factory Default Settings
- Entering Advanced Configuration Mode
- Feature Summary Chart
- Features
- Backlight
- Call Tones
- Channels
- Cloning Mode
- Frequencies
- Bandwidth Range
- Codes, Interference Eliminator Codes (CTCSS/DPL)
- Keypad Beep (or Keypad Tone)
- Keypad Lock
- Low Battery Alert - Shutdown
- Maximum Channels
- Microphone Gain Level
- Monitor
- Nuisance Ch Delete
- Scan Advanced
- Reset to Factory Defaults (2)
- Reverse Burst
- Scan
- Cloning Radio Settings
- Advanced Features
- Troubleshooting
- Use and Care
- Frequencies and Bandwidths
- Accessories
- Batteries
- Audio Accessories
- Carry Accessories
- Chargers
- Programming Accessories
- Limited Warranty for Motorola Personal Communications Products Purchased in the United States and Canada
- Warranty
- I. What This Warranty Covers
- II. Products and Accessories
- III. Products and Accessories (Exclusions)
- IV. Software
- V. Software (Exclusion
- VI. Who is Covered?
- VII. How to Obtain Warranty Service Or Other Information?
- VIII. Software Copyright Notice
- IX. Software Copyright Notice
- X. Patent Notice
- XI. Export Law Assurances
- VL50 Series Programming Quick Reference
Advanced Configuration Mode
27
Factory Default Settings
Your radio is programmed at the factory to the following settings:
To restore the factory settings, turn the radio on while holding
Push to Talk
and
for 3 seconds.
Channel
Frequency
11
22
33
44
55
66
77
487 8
Code
1
Call Tone/
VibraCall
®
Off (0)
VOX
Off (0)
Microphone Gain
2 (medium sensitivity)
6881096C37_.book Page 27 Wednesday, June 3, 2020 2:04 PM