User's Guide

6.9.19.4
Sending Emergency Alarms with Call
This feature allows you to send an Emergency Alarm with
Call to a group of radios. Upon acknowledgement by a
radio within the group, the group of radios can
communicate over a programmed Emergency channel.
If your radio is set to Silent, it does not display any audio or
visual indicators during Emergency mode, or allow any
received calls to sound through the radio’s speaker, until
you press the PTT button to initiate the call.
If your radio is set to Silent with Voice, it does not display
any audio or visual indicators during Emergency mode, but
allow incoming calls to sound through the radio’s speaker.
The indicators only appear once you press the PTT button
to initiate, or respond to, the call.
Follow the procedure to send Emergency Alarms with call
on your radio.
1 Press the programmed Emergency On button.
You see the following:
• The display shows Tx Telegram and the
destination alias.
The green LED lights up. The Emergency icon
appears.
NOTICE:
If programmed, the Emergency Search tone
sounds. This tone is muted when the radio
transmits or receives voice, and stops when
the radio exits Emergency mode. The
Emergency Search tone can be programmed
by your dealer or system administrator.
2 Wait for acknowledgment.
If successful:
• The Emergency tone sounds.
• The red LED blinks.
• The display shows Alarm Sent.
• Your radio enters the Emergency call mode when
the display shows Emergency and the destination
group alias.
English
330