User's Guide

for the One Touch Access button is empty, a
negative indicator tone sounds.
5
Press to end the call. If deaccess code was not
preconfigured in the Contacts list, the first line of the
display shows De- Access Code:. The second line
of the display shows a blinking cursor. Enter the
deaccess code and press the button to
proceed.
• The Dual Tone Multi Frequency (DTMF) tone
sounds and the display shows Ending Phone
Call.
• If the end-call-setup is successful, a tone sounds
and the display shows Call Ended .
• If the end-call-setup is unsuccessful, your radio
returns to the Phone Call screen. Repeat step 3
and step 5 or wait for the telephone user to end
the call.
• When you press PTT button while in the Phone
Contacts screen, a tone sounds and the display
shows Press OK to Place Phone Call.
• When the telephone user ends the call, a tone
sounds and the display shows Phone Call
Ended.
• If the call ends while you are entering the extra
digits requested by the Phone Call, your radio
returns to the screen you were on prior to
initiating the call.
NOTICE:
During channel access, press to dismiss
the call attempt and a tone sounds.
During the call, when you press One Touch
Access button with the deaccess code
preconfigured or enter the deaccess code as
the input for extra digits, your radio attempts
to end the call.
6.8.5.8
Making Phone Calls by Using the
Manual Dial
Follow the procedure to make Phone Calls on your radio by
using the manual dial.
English
261