User's Guide

• If the access code has been preconfigured in the
Contacts list, your radio returns to the screen you
were on before initiating the call.
5 Press the PTT button to respond to the call. Release
the PTT button to listen.
6 Enter extra digits with the keypad if requested by the
call, and press to proceed.
If the call ends while you are entering the extra digits
requested by the call, your radio returns to the
screen you were on before initiating the call.
The Dual Tone Multi Frequency (DTMF) Tone
sounds. Your radio returns to the previous screen.
7
Press
to end the call.
8 Do one of the following:
• If the deaccess code was not preconfigured,
enter the deaccess code when the display shows
De-Access Code:, and press to proceed.
The radio returns to the previous screen.
• Press the programmed One Touch Access
button.
If the entry for the One Touch Access button is
empty, a negative indicator tone sounds.
The DTMF Tone sounds and the display shows
Ending Phone Call.
If the call ends successfully:
• A tone sounds.
• The display shows Call Ended.
If the call fails to end, the radio returns to the Phone
Call screen. Repeat the last two steps or wait for the
telephone user to end the call.
6.8.5.6
Making Phone Calls by Using the
Contacts List
Follow the procedure to make Phone Calls on your radio by
using the Contacts list.
English
257