User's Guide

• The display shows Scan Off.
• The Scan icon disappears.
• The LED turns off.
• A negative indicator tone sounds.
5.10.4
Receive Group List
Receive Group List is a feature that allows you to create
and assign members on the talkgroup scan list.
This list is created when your radio is programmed and it
determines which groups can be scanned. Your radio can
support a maximum of 16 members in this list.
If your radio has been programmed to edit the scan list, you
can:
• Add/remove talkgroups.
• Add, remove, and/or edit priority for talkgroups. Refer to
Editing Priority for a Talkgroup on page 104.
• Add, remove, and/or edit affiliation talkgroups. Refer to
Adding Talkgroup Affiliation on page 105 and Removing
Talkgroup Affiliation on page 106.
• Replace the existing scan list with a new scan list.
If a talkgroup is programmed as Permanent Talkgroup, you
are unable to edit the talkgroup from the scan list.
IMPORTANT:
To add member into the list, the talkgroup must first
be configured in the radio.
NOTICE:
Receive Group List is programmed by the system
administrator. Check with your dealer or system
administrator for more information.
5.10.5
Priority Monitor
The Priority Monitor feature allows the radio to
automatically receive transmission from talkgroups with
higher priority even when radio is in a talkgroup call.
Radio leaves lower priority talkgroup call for higher priority
talkgroup call.
NOTICE:
This feature can only be accessed when Talkgroup
Scan feature is enabled.
Priority Monitor feature applies only to members in the
Receive Group List. There are two Priority Talkgroups:
Priority 1 (P1) and Priority 2 (P2). P1 has higher priority
English
103