Owner's Manual
Table Of Contents
- Safety and General Information
- Caution
- Compliance with RF Exposure Standards
- RF Energy Exposure Awareness and Control
- Information and Operational Instructions for General
- Population and Uncontrolled Environment Use
- Operating Instructions
- Acoustic Safety
- Medical Devices
- Holsters Incorporating Magnets
- Operational Warnings
- Potentially Explosive Atmospheres
- Blasting Caps and Blasting Areas
- Batteries
- Do Not Substitute Options or Accessories
- European Union (EU) Waste of Electrical and Electronic Equipment (WEEE) Directive
- Supplier’s Declaration of Conformity
- Notice to Users (FCC and Industry Canada)
- Licensing Information
- Avis aux utilisateurs (FCC et Industrie Canada)
- Renseignements de licence
- Radio Control Buttons
- Radio Display
- Getting Started
- Basic Radio Operations
- Talking and Listening
- Channels and Frequencies
- Warranty
12
English
2. To copy the channel and Sub-Code combination to all the
other “Members’ radios”, press and hold the button on
the Members’ radios” until you hear a beep. Release the
button after the beep, and wait for the transmission from
the “Leader’s radio.”
Note:
• You will see the icon blinking on the display. This
confirms that the radio is in Easy Pairing mode
waiting to receive the Channel and Sub-Code settings
from the “Leader’s radio”. All “Leader’s radio” will
remain in this mode for three minutes.
• A group with many radios should have all users take
this step at the same time, so all radios can be
programmed together.
3. On the “Leader’s radio”, press and hold down the
button until you hear a double beep.
Note:
• At the double beep, this radio’s Channel and Sub-
Code settings will be transmitted, which will be
received and copied by all the other “Members’
radios”.
• The “Leader’s radio” must make this transmission
when all the “Members’ radios” are still in the Easy
Pairing mode, otherwise the transmission will not be
picked up.
• On the “Leader’s radio”, user must remember not to
release the button on the first (single) beep, otherwise
this radio will become another “Member’s radio”. If
that happens, you can press PTT to escape, and retry
the steps described in Step 3.
• When the “Leader’s radio” does not have sub-code
feature, all “Members’ radios” will have their sub-code
set to zero (Disable). When a radio sub-code is set to
zero, all transmissions received on the channel will be
sent to the speaker, regardless of the sub-code
embedded in the transmission.
• This radio (T110) does not have sub-code feature and
is not compatible with radios with sub-code enabled.
Please ensure all radios in the group have their sub-
code disabled (Sub-code is set to Zero). With Easy
pairing, either use T110 as the leader, or ask the
Leader to set sub-code to zero before performing
easy pairing.
T11X.book Page 12 Tuesday, November 26, 2019 3:03 PM