Owner's Manual
Table Of Contents
- Safety and General Information
- Caution
- Compliance with RF Exposure Standards
- RF Energy Exposure Awareness and Control
- Information and Operational Instructions for General
- Population and Uncontrolled Environment Use
- Operating Instructions
- Acoustic Safety
- Medical Devices
- Holsters Incorporating Magnets
- Operational Warnings
- Potentially Explosive Atmospheres
- Blasting Caps and Blasting Areas
- Batteries
- Do Not Substitute Options or Accessories
- European Union (EU) Waste of Electrical and Electronic Equipment (WEEE) Directive
- Supplier’s Declaration of Conformity
- Notice to Users (FCC and Industry Canada)
- Licensing Information
- Avis aux utilisateurs (FCC et Industrie Canada)
- Renseignements de licence
- Radio Control Buttons
- Radio Display
- Getting Started
- Basic Radio Operations
- Talking and Listening
- Channels and Frequencies
- Warranty
11
English
Menu Options
Roger Beep
Roger beep sounds to indicate the end of a PTT
transmission. It can be heard through the speaker when
Roger Beep is on. It cannot be heard through the speaker if
Roger Beep is turned off.
To turn the Roger Beep off:
Press and hold button, while turning the radio on.
To turn the Roger Beep on:
Turn the radio off and on again without pressing button.
Automatic Power Save
For better battery life, your radio is designed to switch to
Power Save mode when there has been no transmissions
after 3 s. The radio can receive transmissions in this mode.
Easy Pairing
This feature allows a group of radio users to program all their
radios to the same Channel and Sub-Code settings quickly
and simultaneously. Any radio within the group can be
designated as the “Leader’s radio” and have it’s Channel
and Sub-Code settings transmitted to and copied by all the
other radios in the group called “Members’ radios”.
Note: When the “Leader’s radio” has no Sub-Code feature,
such as this radio (T110, all radios in the group will
have their Sub-Code set to zero. When the Sub-Code
is set to zero, all transmissions on the selected
channel will be heard, regardless of the transmitting
radio Sub-Code setting.
1. Pick any of the radios as the “Leader’s radio”. On this
radio, program the Channel and Sub-Code to the desired
settings. See “Selecting the Channel” and “Selecting the
Sub-Code” sections in this user manual. The Sub-Code
for T110 radio is fixed at zero and cannot be
programmed.
Menu Key
Menu Key
Menu Key
Menu Key
Two Way Mode
Channel ()
6FDQ0RGH
0RQLWRU0RGH
T11X.book Page 11 Tuesday, November 26, 2019 3:03 PM