User's Guide
Table Of Contents
- Declaration of Conformity
- Contents
- Important Safety Information
- Notice to Users
- Software Version
- Copyrights
- Computer Software Copyrights
- Introduction
- Basic Operations
- Radio Controls
- Status Indicators
- Zone and Channel Selections
- Calls
- Advanced Features
- Utilities
- Authorized Accessories List
- Batteries and Chargers Warranty
- Limited Warranty
Auto Scan (Automatic)
Your radio automatically starts scanning when you
select a channel or group that has Auto Scan enabled.
Turning Scan On or Off
Follow the procedure to turn scan on or off on your radio.
Do one of the following:
• Press the programmed Scan
button to start or
stop Scan.
• Turn the Channel Selector Knob to select a
channel programmed with Auto Scan enabled.
If scan is enabled:
• The yellow LED blinks.
•
A positive indicator tone sounds.
If scan is disabled:
• The LED turns off.
• A negative indicator tone sounds.
Responding to Transmissions During
Scanning
During scanning, your radio stops on a channel or group
where activity is detected. The radio stays on that channel
for a programmed duration known as hang time. Follow the
procedure to respond to transmissions during scanning.
1
If the Channel Free Indication feature is enabled,
you hear a short alert tone the moment the
transmitting radio releases the PTT button, indicating
the channel is free for you to respond. Press the PTT
button during hang time.
The green LED lights up.
2 Do one of the following:
• Wait for the Talk Permit Tone to end and speak
clearly into the microphone if enabled.
• Wait for the PTT Sidetone to end and speak
clearly into the microphone if enabled.
3 Release the PTT button to listen.
The radio returns to scanning other channels or
groups if you do not respond within the hang time.
English
36