User's Guide
Table Of Contents
- Declaration of Conformity
- Contents
- Important Safety Information
- Notice to Users
- Software Version
- Copyrights
- Computer Software Copyrights
- Introduction
- Basic Operations
- Radio Controls
- Status Indicators
- Zone and Channel Selections
- Calls
- Advanced Features
- Utilities
- Authorized Accessories List
- Batteries and Chargers Warranty
- Limited Warranty
Calls
This chapter explains the operations to receive, respond to,
make, and stop calls.
You can select a subscriber alias or ID, or group alias or ID
after you have selected a channel by using one of these
features:
Programmed One Touch Access Button
This method is used for Group and Private Calls only.
You can only have one ID assigned to a One Touch
Access button with a short or long programmable
button press.
Volume/Channel Selector Knob
This method manually selects a subscriber alias or ID,
or group alias or ID.
The LED lights up solid green while the radio is transmitting
and blinks green when the radio is receiving.
Group Calls
Your radio must be configured as part of a group to receive
a call from or make a call to the group of users.
Making Group Calls
Follow the procedure to make Group Calls on your radio.
1 Do one of the following:
•
Select a channel with the active group alias or ID.
•
Press the programmed One Touch Access
button.
2 Press the PTT button to make the call.
The green LED lights up.
3 Do one of the following:
• Wait for the Talk Permit Tone to end and speak
clearly into the microphone if enabled.
•
Wait for the PTT Sidetone to end and speak
clearly into the microphone if enabled.
4 Release the PTT button to listen.
The green LED blinks when the target radio
responds.
English
26