User Manual
Table Of Contents
- Declaration of Conformity
- Computer Software Copyrights
- Radio Frequency (RF) Exposure Safety Standards
- FCC Licensing Information
- Introduction
- Radio Overview
- Battery and Charger Features
- Batteries and Chargers Safety Information
- Programming The Radio Through the CPS
- Radio Cloning
- Advanced Radio Configuration (*)
- Troubleshooting
- Use and Care
- Radio Frequency and Code Charts
- Motorola Solutions Limited Warranty for the United States and Canada
- Untitled
- Accessories
RADIO OVERVIEW
8
OPERATION WITH MENU SETTINGS
Press Menu button to navigate through the Menu settings. At any time in Menu mode, short press PTT or
wait 3 seconds to exit the menu. Voice Assisted Operation feature may not be available on certain previous
shipping radios.
HOW TO... STEP 1 STEP 2
Change Channel Press Menu button to navigate to Channel. Press +/- button to change
channel.
Enter Monitor Mode Press Menu button to navigate to Monitor. Press +/- button to activate or
deactivate Monitor.
Enter Scan Mode Press Menu button to navigate to Scan. Press +/- button to activate or
deactivate Scan.
Send Call Tone (enabled
through CPS)
Press Menu button to navigate to Call
Tone.
Press +/- button to send Call
Tone.
Quick Tip: It is not necessary to wait for the voice prompt to be completed before continuing with next button press.
Note: For single channel models, Monitor, Scan Mode and Call Tone are supported. Single channel models support Scan mode
when the user enables “Dynamic Talkaround Scan” on a repeater channel via the customer programming software.
2000044_CLP_en.book Page 8 Thursday, November 9, 2017 6:40 PM