User's Guide
Table Of Contents
- Introduction
- FCC Licensing Information
- Interference Information
- RF Energy Exposure Awareness and Control Information and Operational Instructions for Occupational Use
- Federal Communication Commission (FCC) Regulations
- Compliance with RF Exposure Standards
- RF Exposure Compliance and Control Guidelines and Operating Instructions for Two-Way Radio Operations
- Electromagnetic Interference/Compatibility
- Use of Communication Devices While Driving
- Acoustic Safety
- Operational Warnings
- Operational Warnings (Continued)
- Operational Cautions
- Hazard Locations (Intrinsically) Safe Radio Information
- Operational Cautions for Intrinsic Safe Equipment
- Warnings for Radios Approved as Intrinsically Safe
- Repair
- Radio Controls
- Getting Started
- Installing the Swivel Belt Holster
- Installing the Batteries
- Charging the Battery
- Turning Your Radio On and Off
- Adjusting the Volume
- Reading the Display
- Talking and Receiving
- Basic Radio Operation
- Signal Strength and Channel Busy Indicators
- Talk Range
- Handsfree Use (VOX) (CLS1410 only)
- Locking the Keypad
- Monitoring a Channel
- Scanning (CLS1410 Only)
- Programming Mode
- Factory Default Settings
- Entering Programming Mode
- Cloning Radio Settings
- Advanced Features
- Troubleshooting
- Use and Care
- Frequencies and Bandwidths
- Spirit GT Series Programming
- Limited Warranty for Motorola Personal Communications Products Purchased in the United States and Canada
- Warranty
- I. What This Warranty Covers
- II. What the Period of Coverage Is
- III. Who is Covered
- IV. What We Will Do to Correct Warranty Problems
- V. How to Obtain Warranty Service or Other Information
- VI. What This Warranty Does Not Cover
- VII. Some Other Limitations
- VIII. Patent and Software Provisions
- _Series Programming Quick Reference
FCC Licensing Information
4
Changes or modifications not expressly approved by Motorola may void the user’s authority granted by the FCC
to operate this radio and should not be made. To comply with FCC requirements, transmitter adjustments should
be made only by or under the supervision of a person certified as technically qualified to perform transmitter
maintenance and repairs in the private land mobile and fixed services as certified by an organization
representative of the user of those services.
Replacement of any transmitter component (crystal, semiconductor, etc.) not authorized by the FCC equipment
authorization for this radio could violate FCC rules.
Use of this radio outside the country where it was intended to be distributed is subject to government regulations
and may be prohibited