User's Guide
Table Of Contents
- Introduction
- FCC Licensing Information
- Interference Information
- RF Energy Exposure Awareness and Control Information and Operational Instructions for Occupational Use
- Federal Communication Commission (FCC) Regulations
- Compliance with RF Exposure Standards
- RF Exposure Compliance and Control Guidelines and Operating Instructions for Two-Way Radio Operations
- Electromagnetic Interference/Compatibility
- Use of Communication Devices While Driving
- Acoustic Safety
- Operational Warnings
- Operational Warnings (Continued)
- Operational Cautions
- Hazard Locations (Intrinsically) Safe Radio Information
- Operational Cautions for Intrinsic Safe Equipment
- Warnings for Radios Approved as Intrinsically Safe
- Repair
- Radio Controls
- Getting Started
- Installing the Swivel Belt Holster
- Installing the Batteries
- Charging the Battery
- Turning Your Radio On and Off
- Adjusting the Volume
- Reading the Display
- Talking and Receiving
- Basic Radio Operation
- Signal Strength and Channel Busy Indicators
- Talk Range
- Handsfree Use (VOX) (CLS1410 only)
- Locking the Keypad
- Monitoring a Channel
- Scanning (CLS1410 Only)
- Programming Mode
- Factory Default Settings
- Entering Programming Mode
- Cloning Radio Settings
- Advanced Features
- Troubleshooting
- Use and Care
- Frequencies and Bandwidths
- Spirit GT Series Programming
- Limited Warranty for Motorola Personal Communications Products Purchased in the United States and Canada
- Warranty
- I. What This Warranty Covers
- II. What the Period of Coverage Is
- III. Who is Covered
- IV. What We Will Do to Correct Warranty Problems
- V. How to Obtain Warranty Service or Other Information
- VI. What This Warranty Does Not Cover
- VII. Some Other Limitations
- VIII. Patent and Software Provisions
- _Series Programming Quick Reference
_Series Programming Quick Reference
To enter programming mode, press and hold Push to Talk
and T for 3 seconds while turning the radio on. The radio
beeps and displays k, the channel number blinks, and the
frequency (indicated by l) and code (indicated by y)
display alternately.
Set the
Channel*
Press
[
or
].
Set the
Frequency
Press S
until
l displays.
Press [
or
]
to change the
frequency.
Set the
Interference
Eliminator
Code
Press S
until
ydisplays.
Press
[
or
]
to change the
code.
Set
Available
Channels*
Press S until = displays.
Press [
or
] to select number
of available channels.
* CLS1410 Only