User's Guide
Table Of Contents
- Introduction
- FCC Licensing Information
- Interference Information
- RF Energy Exposure Awareness and Control Information and Operational Instructions for Occupational Use
- Federal Communication Commission (FCC) Regulations
- Compliance with RF Exposure Standards
- RF Exposure Compliance and Control Guidelines and Operating Instructions for Two-Way Radio Operations
- Electromagnetic Interference/Compatibility
- Use of Communication Devices While Driving
- Acoustic Safety
- Operational Warnings
- Operational Warnings (Continued)
- Operational Cautions
- Hazard Locations (Intrinsically) Safe Radio Information
- Operational Cautions for Intrinsic Safe Equipment
- Warnings for Radios Approved as Intrinsically Safe
- Repair
- Radio Controls
- Getting Started
- Installing the Swivel Belt Holster
- Installing the Batteries
- Charging the Battery
- Turning Your Radio On and Off
- Adjusting the Volume
- Reading the Display
- Talking and Receiving
- Basic Radio Operation
- Signal Strength and Channel Busy Indicators
- Talk Range
- Handsfree Use (VOX) (CLS1410 only)
- Locking the Keypad
- Monitoring a Channel
- Scanning (CLS1410 Only)
- Programming Mode
- Factory Default Settings
- Entering Programming Mode
- Cloning Radio Settings
- Advanced Features
- Troubleshooting
- Use and Care
- Frequencies and Bandwidths
- Spirit GT Series Programming
- Limited Warranty for Motorola Personal Communications Products Purchased in the United States and Canada
- Warranty
- I. What This Warranty Covers
- II. What the Period of Coverage Is
- III. Who is Covered
- IV. What We Will Do to Correct Warranty Problems
- V. How to Obtain Warranty Service or Other Information
- VI. What This Warranty Does Not Cover
- VII. Some Other Limitations
- VIII. Patent and Software Provisions
- _Series Programming Quick Reference
Spirit GT Series Programming
50
Spirit GT Series Programming
The _Series platform is designed to replace the Spirit GT Series radio. The first
eight frequencies and 38 interference eliminator codes of
_Series are compatible
with Spirit GT Series. To program your
_Series radio to talk with a Spirit GT
Series, verify or change your Spirit GT settings as follows.
To verify the frequency and code:
1. Press the Menu button 3 times. The channel number and frequency display.
2. Press Menu again. The interference eliminator code displays.
To change the frequency:
1. Enter programming mode by pressing and holding
Push to Talk
for
approximately 5 seconds while turning the radio on, then release
Push to Talk
.
2. Use the Scroll button to select one the eight frequencies.
To change the interference eliminator code:
1. Enter programming mode by pressing and holding
Push to Talk
for
approximately 5 seconds while turning the radio on, then release
Push to Talk
.
2. Press the Menu button. The code number blinks.
3. Use the Scroll button to select the code.
To exit programming mode on a Spirit GT Series radio, press
Push to Talk
or the
radio will exit programming mode after five seconds.