User's Guide
Table Of Contents
- Introduction
- FCC Licensing Information
- Interference Information
- RF Energy Exposure Awareness and Control Information and Operational Instructions for Occupational Use
- Federal Communication Commission (FCC) Regulations
- Compliance with RF Exposure Standards
- RF Exposure Compliance and Control Guidelines and Operating Instructions for Two-Way Radio Operations
- Electromagnetic Interference/Compatibility
- Use of Communication Devices While Driving
- Acoustic Safety
- Operational Warnings
- Operational Warnings (Continued)
- Operational Cautions
- Hazard Locations (Intrinsically) Safe Radio Information
- Operational Cautions for Intrinsic Safe Equipment
- Warnings for Radios Approved as Intrinsically Safe
- Repair
- Radio Controls
- Getting Started
- Installing the Swivel Belt Holster
- Installing the Batteries
- Charging the Battery
- Turning Your Radio On and Off
- Adjusting the Volume
- Reading the Display
- Talking and Receiving
- Basic Radio Operation
- Signal Strength and Channel Busy Indicators
- Talk Range
- Handsfree Use (VOX) (CLS1410 only)
- Locking the Keypad
- Monitoring a Channel
- Scanning (CLS1410 Only)
- Programming Mode
- Factory Default Settings
- Entering Programming Mode
- Cloning Radio Settings
- Advanced Features
- Troubleshooting
- Use and Care
- Frequencies and Bandwidths
- Spirit GT Series Programming
- Limited Warranty for Motorola Personal Communications Products Purchased in the United States and Canada
- Warranty
- I. What This Warranty Covers
- II. What the Period of Coverage Is
- III. Who is Covered
- IV. What We Will Do to Correct Warranty Problems
- V. How to Obtain Warranty Service or Other Information
- VI. What This Warranty Does Not Cover
- VII. Some Other Limitations
- VIII. Patent and Software Provisions
- _Series Programming Quick Reference
Programming Mode
33
Entering Programming Mode
Press and hold
Push to Talk
and T for 3 seconds while turning the radio on. The
radio beeps and displays k
, the channel number blinks, and the frequency
(indicated by l) and code (indicated by y) display alternately.
Note:
If you press and release the
Push to Talk
button when programming CSL1410
models, you will return to the front of the Programming Mode.
Selecting a Channel (CLS1410 Only)
1. In programming mode, press S until the channel number blinks
and the frequency and code display alternately (this is the first
setting after you enter programming mode).
2. Press
[or ] to select the channel.
3. Press and hold
Push to Talk
to exit programming mode, or
press S to continue programming.
Configuring the Operating Frequency from a Pre-programmed Frequency List
1. In programming mode, press
S until l displays and the
frequency number blinks.
2. Press
[ or ] to select the frequency.
3. Press and hold
Push to Talk
to exit programming mode, or press
S to continue programming.
Note:
See page 44 for information on frequencies for communicating with other business
radios. If you are matching your _ Series radio to an existing Spirit GT radio, see
page 50.