User's Manual
Table Of Contents
- Contents
- Product Safety
- Introduction
- FCC Licensing Information
- Canada Lisencing Information
- Batteries and Chargers Safety Information
- Radio Overview
- Parts Of The Radio
- Battery Features
- About the Li-Ion Battery
- Battery Recycling and Disposal
- Installing the Lithium-Ion (Li-Ion) Battery
- Removing the Lithium-Ion (Li-Ion) Battery
- Attaching and Removing Antenna
- Installing Spring Action Belt Clip
- Power Supply, Adaptor and Drop-in Tray Charger
- Battery Life Information
- Charging the Battery
- Charging Standalone and Standard Capacity Batteries
- Charging High capacity Battery
- Drop-in Tray Charger LED Indicators
- Rapid Charger LED Indicator
- Estimated Charging Time
- Charging a Radio and Battery using a Multi Unit-Charger - MUC (Optional Accessory)
- Getting Started
- Programming Features
- Advanced Configuration Mode
- Programming Values Example
- Other Programming Features
- Customer Programming Software (CPS)
- Weather Feature
- Cloning Radios
- Troubleshooting
- Use and Care
- Frequency and Code Charts
- Notes
- Motorola Limited Warranty for the United States and Canada
- Accessories
PROGRAMMING
FEATURES
English
56
• Wait for 3 seconds before releasing the
buttons until a distinctive audible tone is
heard.
3. Place the Source radio in the source pocket that
pairs with the target pocket you chose in step 1.
Press and release SB1.
4. After cloning is completed, the Source radio will
sound either a ‘pass’ tone (cloning was
successful) or a ‘fail’ tone (cloning process has
failed). The ‘pass’ tone sounds like a good ke
y
‘chirp’ whereas the ‘fail’ tone sounds similar to a
‘bonk’ tone. If the Source radio is a display
model, it will either show ‘Pass’ or ‘Fail’ on the
display (a tone will be heard within 5 seconds).
5. Once you have completed the cloning process,
turn the radios OFF and ON to exit the ‘cloning’
mode.
• If cloning fails please refer to “What To Do if
Cloning Fails” on page 54.
Further details on how to clone radios are
explained in the Instructions Sheet provided
with the MUC.
When ordering the MUC, please refer to P/N
RLN6309.
Notes:
• Paired Target radios and Source radios must be
of the same band type in order for the cloning to
run successfully.
• (*) MUC pockets numbers should be read from
left to right with the Motorola logo facing front.