User's Manual

English
44
PROGRAMMING FEATURES
To program, connect the RDX Series radio via
the Drop-in Charger Tray and CPS
Programming Cable as shown in Figure 1 on
page 41. Toggle the cable switch of the CPS
Programming Cable to ‘CPS Mode’.
CPS allows you to program frequencies, PL/
DPL Codes as well as other features such as:
Bandwidth Select, Time-out Timer, Power
Select, Scan List, Call Tones, Scramble,
Reverse Burst, etc. CPS is a very useful tool as
it can also lock the Front-Panel Radio
Programming or restrict any specific radio
feature to be changed (to avoid accidentally
erasing the preset radio values). It also
provides security by giving the option to set up
a password for profile radio’s management. For
more information, refer to Features Summary
Chart Section at the end of the User Guide.
Note: (*) CPS Programming Cable P/N#
HKKN4027_ is an accessory sold
separately. Please contact your Motorola
point of purchase for more information.
Time-Out Timer
This timer sets the amount of time that the
radio can continuously transmit before the
transmission is automatically terminated. The
default setting is 60 seconds and can be
changed using the CPS.
Power Select
Power Select allows you to select between
high and low transmission power per frequency
in each channel. The power levels for RDX
High Power are 2/4 for UHF and 2/5 for VHF
Call Tones
Call Tones feature allows you to transmit an
audible tone to other radios on the same
channel to alert them that you are about to talk
or to alert them without speaking.
To use this feature, the Call Tones must be
programmed to either SB1 or SB2 and 1 of the
3 pre-recorded tones is selected.
DRAFT 1