User's Manual
Table Of Contents
- Contents
- Product Safety
- Introduction
- FCC Licensing Information
- Canada Lisencing Information
- Batteries and Chargers Safety Information
- Radio Overview
- Parts Of The Radio
- Battery Features
- About the Li-Ion Battery
- Battery Recycling and Disposal
- Installing the Lithium-Ion (Li-Ion) Battery
- Removing the Lithium-Ion (Li-Ion) Battery
- Attaching and Removing Antenna
- Installing Spring Action Belt Clip
- Power Supply, Adaptor and Drop-in Tray Charger
- Battery Life Information
- Charging the Battery
- Charging Standalone and Standard Capacity Batteries
- Charging High capacity Battery
- Drop-in Tray Charger LED Indicators
- Rapid Charger LED Indicator
- Estimated Charging Time
- Charging a Radio and Battery using a Multi Unit-Charger - MUC (Optional Accessory)
- Getting Started
- Programming Features
- Advanced Configuration Mode
- Programming Values Example
- Other Programming Features
- Customer Programming Software (CPS)
- Weather Feature
- Cloning Radios
- Troubleshooting
- Use and Care
- Frequency and Code Charts
- Notes
- Motorola Limited Warranty for the United States and Canada
- Accessories
English
42
PROGRAMMING FEATURES
OTHER PROGRAMMING FEATURES
Scan
Scan allows you to monitor other channels to
detect conversations. When the radio detects a
transmission, it stops scanning and goes to the
active channel. This allows you to listen and
talk to people in that channel without having to
change channel manually. If there are
transmissions on another channel, you will not
hear that activity once the radio has stopped
scanning. Once the activity on transmitting
channel stops, the radio waits for 5 seconds
before resuming scan again.
• To start scanning, press the SB1 or SB2 button
Note: Scan has to be programmed either to SB1
or SB2 button via CPS. SB2 is by default
Scan/Nuisance Channel delete button.
• To stop scanning, short press the SB1 or SB2
button (programmed for scan) again.
• By pressing the PTT button while the radio is
scanning, the radio will transmit on the channel
which was previously selected before Scan is
activated. If no transmission occurs within 5
seconds, scanning resumes.
• If you want to scan a channel without the
Interference Eliminator Codes (CTCSS/DPL), set
the code settings for the channels to ‘0’ in the
CTCSS/DPL Programming Selection Mode.
Note: Whenever the radio is set to Scan, the LED
Indicator blinks a Red Heartbeat.
Editing Scan List
Scan List can be edited by using the CPS. For
more information refer to “Customer
Programming Software (CPS)” on page 43.
DRAFT 1