User's Manual
Table Of Contents
- Contents
- Product Safety
- Introduction
- FCC Licensing Information
- Canada Lisencing Information
- Batteries and Chargers Safety Information
- Radio Overview
- Parts Of The Radio
- Battery Features
- About the Li-Ion Battery
- Battery Recycling and Disposal
- Installing the Lithium-Ion (Li-Ion) Battery
- Removing the Lithium-Ion (Li-Ion) Battery
- Attaching and Removing Antenna
- Installing Spring Action Belt Clip
- Power Supply, Adaptor and Drop-in Tray Charger
- Battery Life Information
- Charging the Battery
- Charging Standalone and Standard Capacity Batteries
- Charging High capacity Battery
- Drop-in Tray Charger LED Indicators
- Rapid Charger LED Indicator
- Estimated Charging Time
- Charging a Radio and Battery using a Multi Unit-Charger - MUC (Optional Accessory)
- Getting Started
- Programming Features
- Advanced Configuration Mode
- Programming Values Example
- Other Programming Features
- Customer Programming Software (CPS)
- Weather Feature
- Cloning Radios
- Troubleshooting
- Use and Care
- Frequency and Code Charts
- Notes
- Motorola Limited Warranty for the United States and Canada
- Accessories
English
39
PROGRAMMING FEATURES
• Turn OFF the radio and start over.
5. I just programmed the value I wanted. How do I
exit the Programming Mode?
You can either:
• long press the PTT button twice to exit if you’re in
the Programming Mode or,
• Long press the PTT button once if you are
already in the ‘Idle’ Programming mode.
6. I am done programming the features in this
channel. How do I program another channel?
Short press the PTT button several times until
you hear “Channel Number”. Switch channel by
rotating the Channel Selector Knob. If you wish
to save the changes, make sure you are in the
‘Idle’ Programming Mode before switching the
channel, otherwise you will lose the changes
made.
PROGRAMMING VALUES EXAMPLE
Example of Programming a Frequency
Assuming current frequency value is set to
Channel 1, with the UHF default frequency set
to ‘02’ (equivalent to 464.5500 MHz), and you
want to change it to Frequency Number = ‘13’
(which is mapped to 461.1375 MHz), follow this
sequence:
1. Enter Advanced Configuration Mode.
2. Short press the PTT button to enter Frequency
Mode. The radio audible voice announces that
the current value is ‘2’.
3. Press the SB1 button eleven times to increase
frequencies and you will hear frequency “One,
three” (13).
4. Long press the PTT button. LED Indicator
shows a green heartbeat to indicate ‘Idle’
Programming Mode.
5. Long press the PTT button again to exit
Programming Mode or turn OFF the radio.
DRAFT 1