User's Manual
Table Of Contents
- Contents
- Product Safety
- Introduction
- FCC Licensing Information
- Canada Lisencing Information
- Batteries and Chargers Safety Information
- Radio Overview
- Parts Of The Radio
- Battery Features
- About the Li-Ion Battery
- Battery Recycling and Disposal
- Installing the Lithium-Ion (Li-Ion) Battery
- Removing the Lithium-Ion (Li-Ion) Battery
- Attaching and Removing Antenna
- Installing Spring Action Belt Clip
- Power Supply, Adaptor and Drop-in Tray Charger
- Battery Life Information
- Charging the Battery
- Charging Standalone and Standard Capacity Batteries
- Charging High capacity Battery
- Drop-in Tray Charger LED Indicators
- Rapid Charger LED Indicator
- Estimated Charging Time
- Charging a Radio and Battery using a Multi Unit-Charger - MUC (Optional Accessory)
- Getting Started
- Programming Features
- Advanced Configuration Mode
- Programming Values Example
- Other Programming Features
- Customer Programming Software (CPS)
- Weather Feature
- Cloning Radios
- Troubleshooting
- Use and Care
- Frequency and Code Charts
- Notes
- Motorola Limited Warranty for the United States and Canada
- Accessories
English
36
PROGRAMMING FEATURES
Reading CTCSS / DPL Values
Cycle through the features available for
configuration by short pressing the PTT button
until you hear the current code. The radio
moves to the programming CTCSS/PL codes
mode.
Enter a new code value using the SB1 and SB2
buttons.
The RDX Series radios have up to 219 codes
available. For more information, refer to
“Frequency and Code Charts” on page 64.
Reading Auto-Scan Values
After hearing the CTCSS/DPL codes, short
pressing the PTT button moves you to Auto-
Scan mode.
Auto-Scan has only two values:
• Enabled
• Disabled
Active Channels
While in Auto-Scan mode, short pressing the
PTT button shifts the radio to ‘Active
Channels’ feature.
Modify the amount of channels available using
the SB1 and SB2 buttons.
Weather Channel Programming (Not for
RDU4103+)
After setting the amount of Active Channels,
short pressing the PTT button moves you to
Weather Channel feature.
Use the SB1 and SB2 buttons to Enable/
Disable the feature.
Saving Settings
Once you are satisfied with the settings, you
can either:
•
short press the PTT button to
continue programming,
•
long press the PTT button to save and return to
‘Idle’ Programming Mode, or
• long press the PTT button twice to exit ‘Idle’
DRAFT 1