User's Manual
Table Of Contents
- Contents
- Product Safety
- Introduction
- FCC Licensing Information
- Canada Lisencing Information
- Batteries and Chargers Safety Information
- Radio Overview
- Parts Of The Radio
- Battery Features
- About the Li-Ion Battery
- Battery Recycling and Disposal
- Installing the Lithium-Ion (Li-Ion) Battery
- Removing the Lithium-Ion (Li-Ion) Battery
- Attaching and Removing Antenna
- Installing Spring Action Belt Clip
- Power Supply, Adaptor and Drop-in Tray Charger
- Battery Life Information
- Charging the Battery
- Charging Standalone and Standard Capacity Batteries
- Charging High capacity Battery
- Drop-in Tray Charger LED Indicators
- Rapid Charger LED Indicator
- Estimated Charging Time
- Charging a Radio and Battery using a Multi Unit-Charger - MUC (Optional Accessory)
- Getting Started
- Programming Features
- Advanced Configuration Mode
- Programming Values Example
- Other Programming Features
- Customer Programming Software (CPS)
- Weather Feature
- Cloning Radios
- Troubleshooting
- Use and Care
- Frequency and Code Charts
- Notes
- Motorola Limited Warranty for the United States and Canada
- Accessories
RADIO OVERVIEW
English
23
Charging a High Capacity Battery
To convert the charger from the default setup to
accommodate the High capacity or Ultra High
capacity battery:
1. Squeeze both tabs on each side of the
removable bracket in the drop-in charger tray
and lift the bracket from the charger tray.
2.
Rotate the removable bracket 180 degrees and
replace it by fitting it in the charger slot until it
snaps. The label on the removable bracket
should show ‘High Capacity Battery’ facing
front of the charger.
3. Repeat same procedure to return to the
charging a Standard Battery position. Label on
the removable bracket should show ‘Standar
d
Battery’ facing front.
Note: Make sure the bracket is assembled
correctly for both standalone battery and
battery (with radio)
Removable
Piece
Removable
Piece
Turn around
horizontal
180 degree