User's Manual
Table Of Contents
- Contents
- Safety
- Introduction
- Batteries and Chargers Safety Information
- FCC Licensing Information
- Radio Overview
- Getting Started
- Programming Features
- Troubleshooting
- Use and Care
- Frequency and Code Charts
- Motorola Limited Warranty for the United States and Canada
- Accessories
- RM Series Features Summary
- Programmable Buttons Chart
- Blank Page
- Blank Page
- Blank Page
PROGRAMMING
FEATURES
English
52
•
Wait for 3 seconds before releasing the
buttons until a distinctive audible tone is
heard and ‘Cloning’ is announced.
3.
Place the Source radio in the source pocket that
pairs with the target pocket you chose in step 1.
Short press SB1 on Source radio.
4.
After cloning is completed, the Source radio will
announce either ‘Successful’ (cloning was
successful) or ‘failed’ (cloning process has failed).
5.
Once you have completed the cloning process,
turn the radios OFF and ON to exit the ‘cloning’
mode.
•
If cloning fails please refer to “What To Do if
Cloning Fails” on page 54.
Further details on how to clone radios are
explained in the Instructions Sheet provided
with the MUC.
When ordering the MUC, please refer to
P/N PMLN6384A.
•
Paired Target radios and Source radios
must be of the same band type in order for
the cloning to run successfully.
•
MUC pockets numbers should be read from
left to right with the Motorola logo facing
front.
Notes