User's Manual

PROGRAMMING
FEATURES
English
40
Reading CTCSS/DPL Values
If you continue short pressing the PTT button
the radio will move forward to programming
CTCSS/PL Codes.
After hearing the current value for CTCSS/PL
Code you can scroll to a new code value using
the SB1 or SB2 button.
RM Series have up to 219 codes available
(refer to “Frequencies and Codes Charts”
Section).
Reading Auto-Scan Values
After hearing the CTCSS/DPL codes, short
press the PTT button and the radio will move
forward to programming Auto-Scan.
Auto-Scan only has two values:
- Enabled
- Disabled
If you continue short pressing the PTT button
the radio will move forward to programming
Active Channels.
Again, another short pressing the PTT, the
radio will advance to enable/disable
Weather Channels.
Saving Settings
If you are satisfied with the setting, you
can either:
•
short press PTT to continue
programming,
•
long press PTT to save and return to
'Idle' Programming Mode, or
•
long press the PTT button twice to exit
'Idle' Programming Mode and return to
the normal radio operation.
Note:
•
If you do not wish to save the value you just
programmed, turn the radio OFF or switch the
Freq knob before radio entering idle mode
•
If you ‘roll-over’ to the beginning of ‘Idle’
Programming Mode you will hear "Channel #" and
the LED Indicator will show a green heartbeat
again. All values that were changed will be
automatically saved.
•
If long PTT press or radio return to "Idle"
Programming mode, radio will save the changes.
•
return to normal radio operation if the
radio is already in idle mode or