User's Guide
Table Of Contents
- Declaration of Conformity
- Important Safety Information
- Software Version
- Informations importantes sur la sécurité
- Version du logiciel
- Computer Software Copyrights
- Documentation Copyrights
- Disclaimer
- Getting Started
- Preparing Your Radio for Use
- Charging the Battery
- Attaching the Battery‡
- Installing the Antenna
- Attaching the Accessory Connector Cover
- Installing Accessories with GCAI Connector
- Turning On Your Radio‡
- Adjusting the Volume†
- Pairing Radio with Pod and Earpiece†‡
- Pairing Radio with Mission Critical Remote Control Unit (RCU)
- Using the Carry Holster
- Tying Your Radio and Flexible Antenna to Your Body
- Identifying Radio Controls
- Identifying Status Indicators
- General Radio Operation
- Advanced Features
- Advanced Call Features
- Scan
- Call Alert Paging†‡
- Emergency Operation†‡
- Man Down†‡
- Secure Operations
- Trunking System Controls†‡
- Mission Critical Wireless - Bluetooth® -†‡
- Turning the Bluetooth On
- Turning the Bluetooth Off
- Re-Pair Timer
- Bluetooth Drop Timer
- Pairing the Bluetooth Device with Your Radio
- Indicating the Bluetooth Connection is Lost
- Turning the Bluetooth Audio On (Routing the Audio from Your Radio to the Headset)
- Turning the Bluetooth Audio Off (Routing the Audio from the Headset to Your Radio)
- Adjusting the Volume of Your Radio from Bluetooth Audio Device
- Clearing All Bluetooth Devices Information
- Programming Over Project 25 (POP 25) (ASTRO 25 and ASTRO Conventional)
- Utilities
- Flipping the Display on DRSM‡
- Controlling the Display Backlight‡
- Locking and Unlocking the Controls†‡
- Turning Voice Mute On or Off†‡
- Using the Time-Out Timer
- Using the Conventional Squelch Operation Features
- Using the Digital PTT ID Feature‡
- Using the Smart PTT Feature (Conventional Only)
- Voice Announcement†
- Helpful Tips
- Accessories
- Appendix: Maritime Radio Use in the VHF Frequency Range
- Glossary
- Commercial Warranty
Advanced Features
English
46
Testing the Man Down Feature
Note: Enable the Emergency feature with Silent Alarm
disabled, but not in Surveillance Mode before running
this test on your radio.
Procedure:
When Man Down is enabled on your radio:
1 Turn your radio on and place in the vertical position, for at
least 5 seconds.
2 Lay your radio down in the horizontal position.
3 Wait for alert tone.
4 Your radio alerts with audible tone and displays MAN-
DOWN.
OR
If no tone is heard, make sure that the Man Down feature is
enabled on your radio. If Man Down feature was not
enabled, please enable it and go through steps 1,2 and 3
again.
OR
If the Man Down feature is enabled and no tone is heard,
send your radio to a qualified technician.
Handling Man Down Functional Error Messages
Procedure:
1 If your radio display shows one of the following error
messages: HW BOARD ABSENT, MAND HW ERROR or HW
BRD MISMATCH. Send your radio to the qualified technician
to fix this error.
APX_3000_M1.book Page 46 Wednesday, December 5, 2012 11:04 AM