User's Guide
Table Of Contents
- Declaration of Conformity
- Important Safety Information
- Software Version
- Informations importantes sur la sécurité
- Version du logiciel
- Computer Software Copyrights
- Documentation Copyrights
- Disclaimer
- Getting Started
- Preparing Your Radio for Use
- Charging the Battery
- Attaching the Battery‡
- Installing the Antenna
- Attaching the Accessory Connector Cover
- Installing Accessories with GCAI Connector
- Turning On Your Radio‡
- Adjusting the Volume†
- Pairing Radio with Pod and Earpiece†‡
- Pairing Radio with Mission Critical Remote Control Unit (RCU)
- Using the Carry Holster
- Tying Your Radio and Flexible Antenna to Your Body
- Identifying Radio Controls
- Identifying Status Indicators
- General Radio Operation
- Advanced Features
- Advanced Call Features
- Scan
- Call Alert Paging†‡
- Emergency Operation†‡
- Man Down†‡
- Secure Operations
- Trunking System Controls†‡
- Mission Critical Wireless - Bluetooth® -†‡
- Turning the Bluetooth On
- Turning the Bluetooth Off
- Re-Pair Timer
- Bluetooth Drop Timer
- Pairing the Bluetooth Device with Your Radio
- Indicating the Bluetooth Connection is Lost
- Turning the Bluetooth Audio On (Routing the Audio from Your Radio to the Headset)
- Turning the Bluetooth Audio Off (Routing the Audio from the Headset to Your Radio)
- Adjusting the Volume of Your Radio from Bluetooth Audio Device
- Clearing All Bluetooth Devices Information
- Programming Over Project 25 (POP 25) (ASTRO 25 and ASTRO Conventional)
- Utilities
- Flipping the Display on DRSM‡
- Controlling the Display Backlight‡
- Locking and Unlocking the Controls†‡
- Turning Voice Mute On or Off†‡
- Using the Time-Out Timer
- Using the Conventional Squelch Operation Features
- Using the Digital PTT ID Feature‡
- Using the Smart PTT Feature (Conventional Only)
- Voice Announcement†
- Helpful Tips
- Accessories
- Appendix: Maritime Radio Use in the VHF Frequency Range
- Glossary
- Commercial Warranty
Advanced Features
English
41
Note: The timer of this long press can be preprogrammed.
Consult your qualified technician to program the
duration required.
Sending an Emergency Alarm with Emergency
Call
Procedure:
1 Press the preprogrammed Emergency button.
2 The display shows EMERGNCY and the current zone or
channel. A short, medium-pitched tone sounds and the
LED blinks red momentarily.
OR
An invalid tone sounds, if the selected channel does not
support emergency.
3 Your radio enters the Emergency Call state when:
You receive your dispatcher’s acknowledgment. The display
shows ACK RCVD.
OR
You receive no acknowledgement. The display shows
NO ACK.
OR
You press the PTT button while in the Emergency Alarm
mode.
4 Press and hold the PTT button. Speak clearly with the
microphone near your mouth.
5 Release the PTT button to end the transmission and wait for
a response from your dispatcher.
6 Press and hold the preprogrammed Emergency button until
your radio exits the Emergency Call mode.
Note: The timer of this long press can be preprogrammed.
Consult the qualified technician to program the
duration required.
APX_3000_M1.book Page 41 Wednesday, December 5, 2012 11:04 AM