User's Guide
Table Of Contents
- Declaration of Conformity
- Important Safety Information
- Software Version
- Informations importantes sur la sécurité
- Version du logiciel
- Computer Software Copyrights
- Documentation Copyrights
- Disclaimer
- Getting Started
- Preparing Your Radio for Use
- Charging the Battery
- Attaching the Battery‡
- Installing the Antenna
- Attaching the Accessory Connector Cover
- Installing Accessories with GCAI Connector
- Turning On Your Radio‡
- Adjusting the Volume†
- Pairing Radio with Pod and Earpiece†‡
- Pairing Radio with Mission Critical Remote Control Unit (RCU)
- Using the Carry Holster
- Tying Your Radio and Flexible Antenna to Your Body
- Identifying Radio Controls
- Identifying Status Indicators
- General Radio Operation
- Advanced Features
- Advanced Call Features
- Scan
- Call Alert Paging†‡
- Emergency Operation†‡
- Man Down†‡
- Secure Operations
- Trunking System Controls†‡
- Mission Critical Wireless - Bluetooth® -†‡
- Turning the Bluetooth On
- Turning the Bluetooth Off
- Re-Pair Timer
- Bluetooth Drop Timer
- Pairing the Bluetooth Device with Your Radio
- Indicating the Bluetooth Connection is Lost
- Turning the Bluetooth Audio On (Routing the Audio from Your Radio to the Headset)
- Turning the Bluetooth Audio Off (Routing the Audio from the Headset to Your Radio)
- Adjusting the Volume of Your Radio from Bluetooth Audio Device
- Clearing All Bluetooth Devices Information
- Programming Over Project 25 (POP 25) (ASTRO 25 and ASTRO Conventional)
- Utilities
- Flipping the Display on DRSM‡
- Controlling the Display Backlight‡
- Locking and Unlocking the Controls†‡
- Turning Voice Mute On or Off†‡
- Using the Time-Out Timer
- Using the Conventional Squelch Operation Features
- Using the Digital PTT ID Feature‡
- Using the Smart PTT Feature (Conventional Only)
- Voice Announcement†
- Helpful Tips
- Accessories
- Appendix: Maritime Radio Use in the VHF Frequency Range
- Glossary
- Commercial Warranty
Advanced Features
English
36
Using the Dynamic Regrouping Feature (Trunking
Only)†‡
This feature allows the dispatcher to temporarily reassign
selected radios to a particular channel where they can
communicate with each other. This feature is typically used
during special operations and is enabled by a qualified radio
technician.
You will not notice whether your radio has this feature enabled
until a dynamic regrouping command is sent by your dispatcher.
Note: If you try to access a zone or channel that has been
reserved by your dispatcher as a dynamically
regrouped mode for other users, an invalid tone
sounds.
Procedure:
1 When your radio is dynamically regrouped, it automatically
switches to the dynamically regrouped channel. A “gurgle”
tone sounds and the display shows the dynamically
regrouped channel’s name.
2 Press the PTT button to talk. Release PTT button to listen.
When your dispatcher cancels dynamic regrouping, your radio
automatically returns to the zone and channel that you were
using before your radio was dynamically regrouped.
Requesting a Reprogram (Trunking Only)†‡
This feature allows you to notify your dispatcher when you want
a new dynamic regrouping assignment.
Procedure:
1 Press the preprogrammed Reprogram Request button to
send reprogram request to your dispatcher.
2 The display alternates between RPGM and PLS WAIT.
3 If you hear five beeps, your dispatcher has acknowledged
the reprogram request. The display shows ACK RCVD.
OR
If your dispatcher does not acknowledge the reprogram
request within six seconds, a low-pitched alert tone sounds
and the display shows NO ACK.
APX_3000_M1.book Page 36 Wednesday, December 5, 2012 11:04 AM