User's Guide
Table Of Contents
- Declaration of Conformity
- Important Safety Information
- Software Version
- Informations importantes sur la sécurité
- Version du logiciel
- Computer Software Copyrights
- Documentation Copyrights
- Disclaimer
- Getting Started
- Preparing Your Radio for Use
- Charging the Battery
- Attaching the Battery‡
- Installing the Antenna
- Attaching the Accessory Connector Cover
- Installing Accessories with GCAI Connector
- Turning On Your Radio‡
- Adjusting the Volume†
- Pairing Radio with Pod and Earpiece†‡
- Pairing Radio with Mission Critical Remote Control Unit (RCU)
- Using the Carry Holster
- Tying Your Radio and Flexible Antenna to Your Body
- Identifying Radio Controls
- Identifying Status Indicators
- General Radio Operation
- Advanced Features
- Advanced Call Features
- Scan
- Call Alert Paging†‡
- Emergency Operation†‡
- Man Down†‡
- Secure Operations
- Trunking System Controls†‡
- Mission Critical Wireless - Bluetooth® -†‡
- Turning the Bluetooth On
- Turning the Bluetooth Off
- Re-Pair Timer
- Bluetooth Drop Timer
- Pairing the Bluetooth Device with Your Radio
- Indicating the Bluetooth Connection is Lost
- Turning the Bluetooth Audio On (Routing the Audio from Your Radio to the Headset)
- Turning the Bluetooth Audio Off (Routing the Audio from the Headset to Your Radio)
- Adjusting the Volume of Your Radio from Bluetooth Audio Device
- Clearing All Bluetooth Devices Information
- Programming Over Project 25 (POP 25) (ASTRO 25 and ASTRO Conventional)
- Utilities
- Flipping the Display on DRSM‡
- Controlling the Display Backlight‡
- Locking and Unlocking the Controls†‡
- Turning Voice Mute On or Off†‡
- Using the Time-Out Timer
- Using the Conventional Squelch Operation Features
- Using the Digital PTT ID Feature‡
- Using the Smart PTT Feature (Conventional Only)
- Voice Announcement†
- Helpful Tips
- Accessories
- Appendix: Maritime Radio Use in the VHF Frequency Range
- Glossary
- Commercial Warranty
Identifying Status Indicators
English
23
LED Indicators in Surveillance Mode†
For covert operation, the LED can be preprogrammed to be
turned off at specific zone or channel. During operation in these
zone or channel the LED blinking is not seen, instead Voice
Announcement can be used to hear and confirm the operation
status.
Hence, It is recommended to duplicate the channel
programming into a separate zone and have the associated
Voice Announcement tied to zone to help indicate the LED on/
off state, for example “Light Off” “Zone 1”. Using zone control in
this case eases going into and out of the zone or channel
preprogrammed with the LED on/off setting.
Solid green
Short blinking blue
with long interval
Radio is reading or upgrading by CPS.
–
Blinking blue three
times
Bluetooth is powering on or off.
– Slow Blinking blue Radio is waiting to be paired when no device is connected with radio in Bluetooth.
–
Blinking blue at
heartbeat pace
Radio is connected with at least a device in Bluetooth link.
–
Solid blue for two
seconds
Bluetooth device is connected.
Bluetooth device is disconnected.
– Blinking blue Radio is clearing Bluetooth pairing information.
–
Rapid blinking blue
for two seconds
Radio fails to connect or disconnect from a device.
– Solid blue Radio is powering up with Option Board error.
Note: No LED indication occurs when your radio receives a clear (non-secured) transmission in trunking Mode.
Transmit/Receive LED Bluetooth LED Status
APX_3000_M1.book Page 23 Wednesday, December 5, 2012 11:04 AM