User's Manual
Table Of Contents
- Computer Software Copyrights
- Radio Frequency (RF) Exposure Safety Standards
- FCC Licensing Information
- Introduction
- Radio Overview
- Battery and Charger Features
- Batteries and Chargers Safety Information
- Programming The Radio Through the CPS
- Radio Cloning
- Advanced Radio Configuration (*)
- CLP Repeater Capability: Working with RPX
- Troubleshooting
- Use and Care
- Radio Frequency and Code Charts
- Motorola Limited Warranty for the United States and Canada
- Accessories
RADIO CLONING
28
Cloning Radios using the CLP Series Multi-
Unit Charger (MUC) Kit P/N HKPN4007
(optional accessory)
1. To put the source radio into clone mode,
press and hold PTT and the “-” button while
turning the radio ON until you hear the
Cloning Tone and Double Blinking Orange
on the Smart Status Glow.
2. Place the source radio into one of the
charging pockets that has the “CLONE”
label.
3. Turn the target radio ON and place it in the
pairing charging pocket that has the
“CLONE” label and start the cloning process.
4. Press the “Menu” button on the source radio
to start the cloning process. The source
radio generates the start clone tone.
5. Once the cloning is completed, turn the
target radio OFF and back ON again in order
to activate the radio.
6. To clone another radio, repeat steps 3, 4 and
5.
7. To exit clone mode on the source radio, turn
the radio OFF.
Cloning the Radio through a Multi-Unit
Charger