User's Manual
Table Of Contents
- Computer Software Copyrights
- Radio Frequency (RF) Exposure Safety Standards
- FCC Licensing Information
- Introduction
- Radio Overview
- Battery and Charger Features
- Batteries and Chargers Safety Information
- Programming The Radio Through the CPS
- Radio Cloning
- Advanced Radio Configuration (*)
- CLP Repeater Capability: Working with RPX
- Troubleshooting
- Use and Care
- Radio Frequency and Code Charts
- Motorola Limited Warranty for the United States and Canada
- Accessories
30
CLP REPEATER CAPABILITY:
WORKING WITH RPX
CLP REPEATER
CAPABILITY: WORKING
WITH RPX
CLP REPEATER CAPABILITY
Use the Single Unit Charger or use the pocket with
“PROG” label on the Multi-Unit Charger to clone
the RPX.
Note: Connect the RDX Serial Clone Cable (P/N
RLN6303) and the Mini-USB to the Micro-USB
Adapter Cable in order to link the CLP and RPX
units.
INSTRUCTIONS
1. To put the CLP radio into clone mode, press
and hold PTT and the “-” button while turning
the radio ON until you hear the Cloning Tone
and Blinking Orange on the Smart Status
Glow.
Programming the RPX through a
Single Unit Charger
1. Place the CLP radio into the charging
pocket.
2. Connect the micro-USB plug of the micro-
USB adapter cable with the RDX Serial
Clone Cable into the micro-USB receptable
charging pockets.
3. Connect the Mini-USB plug of the RDX
Serial Clone Cable into the RPX Mini-USB
receptable.
Programming the RPX through a Single Unit
Charger