User's Manual
Table Of Contents
- Computer Software Copyrights
- Radio Frequency (RF) Exposure Safety Standards
- FCC Licensing Information
- Introduction
- Radio Overview
- Battery and Charger Features
- Batteries and Chargers Safety Information
- Programming The Radio Through the CPS
- Radio Cloning
- Advanced Radio Configuration (*)
- CLP Repeater Capability: Working with RPX
- Troubleshooting
- Use and Care
- Radio Frequency and Code Charts
- Motorola Limited Warranty for the United States and Canada
- Accessories
RADIO OVERVIEW
8
OPERATION WITH MENU SETTINGS
Press Menu button to navigate through the Menu settings. Voice Assisted Operation feature* (* may not be
available on certain previous shipping radios) At any time in Menu mode, short press PTT or wait 3
seconds to exit the menu.
HOW TO... STEP 1 STEP 2
Change Channel Press Menu button to navigate to Channel. Press +/- button to change
channel.
Enter Monitor Mode Press Menu button to navigate to Monitor. Press +/- button to activate or
deactivate Monitor.
Enter Scan Mode Press Menu button to navigate to Scan. Press +/- button to activate or
deactivate Scan.
Send Call Tone (enabled
through CPS)
Press Menu button to navigate to Call
Tone.
Press +/- button to send Call
Tone.
Quick Tip: It is not necessary to wait for the voice prompt to be completed before continuing with next button press.
Note: For single channel models, Monitor, Scan Mode and Call Tone are supported. Single channel models support Scan mode
when the user enables “Dynamic Talkaround Scan” on a repeater channel via the customer programming software.