User's Manual
Table Of Contents
- Computer Software Copyrights
- Radio Frequency (RF) Exposure Safety Standards
- FCC Licensing Information
- Introduction
- Radio Overview
- Battery and Charger Features
- Batteries and Chargers Safety Information
- Programming The Radio Through the CPS
- Radio Cloning
- Advanced Radio Configuration (*)
- CLP Repeater Capability: Working with RPX
- Troubleshooting
- Use and Care
- Radio Frequency and Code Charts
- Motorola Limited Warranty for the United States and Canada
- Accessories
RADIO OVERVIEW
6
Turning the Radio On and Off
• To turn the radio ON, press and hold the Power/
Battery button until you hear a short tone and the
Smart Status Glow lights up.
• To turn it OFF, press and hold the button until you
hear a short tone and the Smart Status Glow
(red) indicator blinks once.
Adjusting the Volume
Turn the radio ON and set volume level by
pressing volume control (+/- button). A total of 16
volume levels are available.
Installing and Removing the Swivel Belt
Clip Holster
1. Slide the bottom of the radio into the holster.
2. Snap the top of the holster into the radio around
the accessory connector.
3. To remove the holster, pull either the top or
bottom tab(s) and pull the radio from the holster.
Note: When using a corded audio accessory, loop the
cord into the recess in the rear of the holster for
optimal plug retention.
4. Make a small loop in the cord. Pass the cord
through the cord guide, nest the cord in the
U-shaped groove. Pull tight to lock the cord in
place.
5. Turn the belt clip to the position as needed.
Cord
Guide
U-Shaped
Groove