User's Manual
Table Of Contents
- DISTRIBUTED I/O SYSTEM
- CONTENTS
- INTRODUCTION
- INSTALLATION
- THE DIOS PIU AND PICCOLO-XR UNITS
- APPENDIX A: PIU and PICCOLO-XR SPECIFICATIONS
- APPENDIX B: MODELS and ACCESSORIES
- APPENDIX C: ANTENNA
- APPENDIX D: PIU/PICCOLO–XR MOUNTING TEMPLATES
Installation
16
External Power Supply Connections
Use the applicable cable from the V152AH PIU installation kit
to connect the PIU to Motorola standard controller power
supply.
1. Release the screw at the top of the battery chamber
door and slide the door out, as shown in Figure 10.
2. Connect one end of the cable to the DC power input
connector on the back of the unit.
3. Connect the other end of the cable to the power supply
output of a Motorola controller.
4. Close the battery
chamber door and secure with the
screw.