User's Manual
Table Of Contents
- DISTRIBUTED I/O SYSTEM
- CONTENTS
- INTRODUCTION
- INSTALLATION
- THE DIOS PIU AND PICCOLO-XR UNITS
- APPENDIX A: PIU and PICCOLO-XR SPECIFICATIONS
- APPENDIX B: MODELS and ACCESSORIES
- APPENDIX C: ANTENNA
- APPENDIX D: PIU/PICCOLO–XR MOUNTING TEMPLATES
Installation
10
Mounting the PIU Using a Bracket
1. Using four M3x6 or M3x8 screws, attach a bracket
(not supplied) to the back of the PIU. The upper two
bracket holes must be 3.19" (81 mm) apart, and the
lower two bracket holes must be 2.40" (61 mm) apart
and 2.13" (54 mm) below the upper holes, as shown in
Figure 6.
2. Attach the bracket to the m
ounting surface.
2.13"
54mm
2.40"
61 mm
3.19"
81mm
Figure 6
PIU Installation– Bracket Mount dimension