User's Manual

Appendix D: Battery Replacement
38
12. Solder the capacitor leg connections from the top of
the circuit board, using caution to avoid damaging
other components on the board.
13. Check that the data input wires are properly connected
to the connector and that the antenna is properly
soldered.
14. Peel the liner off a new protective pad (part number
7588383V66) and adhere it to the side of the new
capacitor, parallel to circuit board, as shown in Figure
13 above.
15. Carefully slide the circuit board back into the housing,
taking care not to disturb the antenna connection to the
board.
16. With a screwdriver, replace the three screws at the
bottom of the transmitter, applying torque of 6 in-lb.
Note: If it is convenient, the data input wire can be
disconnected from the internal connector before soldering
and reconnected after the battery and capacitor are
replaced.