User's Manual

Appendix D: Battery Replacement
37
!
C a u t i o n
When soldering battery terminals, use caution to
take care not to damage any other components on
the circuit board.
5. Remove the old battery from the circuit board.
!
W A R N I N G
!
Always replace the battery with the type specified in
this document to avoid risk of explosion.
Dispose of used batteries according to manufacturer
instructions and local environmental laws.
6. Using a soldering iron, heat the legs on the capacitor
connection until they become soft.
Capacitor
Terminal
Capacitor
Terminals
Figure 15
Capacitor Terminals- Top View for Soldering
7. Remove the capacitor from the circuit board.
8. Peel the liner off a new protective pad (part number
7588383V65) and adhere it to the side of a new battery,
as shown in Figure 13 above.
9. Place the new battery on the circuit board and secure
with a new plastic strip, as shown in Figure 13 above.
10. Solder the battery leg connections from the top of the
circuit board, using caution to avoid damaging other
components on the board.
11. Place a new capacitor on the circuit board, as shown in
Figure 13 above.