User's Manual

35
APPENDIX D: BATTERY
REPLACEMENT
Replacing the Battery
If it is necessary to replace the internal lithium battery,
follow the procedure below:
1. Using a screwdriver, unscrew the three screws at the
bottom of the transmitter.
2. Pull the housing away from the base to expose the
printed circuit board.
Housing
Screws
Antenna
Wire
Data Wires
Data Input
Wire
Connector
Figure 12
AMR RF Transmitter- Exploded View
!
C a u t i o n
When opening, closing and soldering the transmitter
unit, take care not to damage the soldered
connection of the antenna wire to the circuit board.