User's Manual

Appendix C: The AMR ToolBox
30
+
-
Data Wires
PC with
ToolBox S/W
Transmitter Programmer
9V/12V DC
RS232
Green
Black
Figure 11
Programming Equipment Setup
1. If the AMR RF transmitter is already connected to the
meter, cut the data input wires (as close to the end as
possible) and expose the tips.
!
C a u t i o n
If the wires are connected incorrectly, the equipment
may be damaged.
2. Connect the programmer unit to a DC power source.
For a standard 9V DC battery, use the short power
cable supplied with the Programming Kit. For a
12VDC battery, insert the protection board
(FCN6538A) into the DC power connector on the back
of the programmer unit and then attach the 7 ft power
cable (supplied with the Programming Kit).
3. Connect the programmer unit to the ToolBox PC,
using the RS232 cable and RS232 connector
(FTN6597A) supplied with the Programming Kit.
4. Power up the programmer unit by inserting the On/Off
TB supplied with the Programming Kit into the GND
connector.