User's Manual

Installation
17
Data Wires
Transmitter
Ejot
M4x14 Screws
+ SST
Washers
Pit Lid
Spring Washer
Top Protective
Antenna Cover
Nut
Bracket
Figure 9
AMR Transmitter Mounted on Pit Lid
10. Thread the transmitter input wires through the small
wire hole at the base of the bracket (see Figure 8) OR
attach transmitter wires to side of bracket, threading a
strip (not supplied) through the small wire hole at the
base of the bracket.
11. Connect the transmitter wires to the meter wires, using
gel cups (not supplied) to seal the connection. Use a
3M™ recommended tool to squeeze the gel cup until
the connection is sealed.
- If the meter wires are floating, connect the two data
wires to the meter wires.
- If one of the meter wires is connected to the
ground/common (-), connect it to the black wire on the
transmitter and connect the green wire to the switch
(+).
The transmitter wires are 18" (45.7 cm) long. If this is
not adequate to reach the meter, add up to 100 ft (30
m) of AWG20 wire.