User's Manual

Installation
16
A
ntenna
Cover
Bracket
Pit Lid
Washer
Nut
W
ire Hole
Figure 8
Bracket Attached to Pit Lid
!
C a u t i o n
Do not exert torque of more than 40 ± 5 in-lb on
the nut or it may be damaged.
7. Invert the lid and bracket and place carefully on the
ground, resting the full weight on the top of the
antenna cover (with the Motorola symbol).
8. Insert the antenna (attached to the transmitter)
downwards through the antenna hole at the bottom of
antenna cover (see Figure 6) until the transmitter
housing meets the threaded base of the antenna cover.
9. Secure the transmitter to the bracket with two Ejot
M4x14 stainless steel screws and two stainless steel
flat washers, inner diameter: 0.17", outer diameter
3/8", thickness 0.032" (supplied) as shown in Figure 9.