User's Manual

Installation
14
Pit Installation
!
C a u t i o n
The AMR transmitter should be enabled before
installing. See the Enabling the Transmitter
section above.
!
C a u t i o n
Before installing the AMR transmitter, make
sure that the transmission frequency and
transmissions rate are appropriate. If not,
reprogram as described in Appendix C and the
AMR ToolBox User Guide.
The AMR transmitter can be installed in a meter pit with a
metal or plastic lid. Before installing, verify that the
available space is at least 10" (25.4 cm) deep and 4.7"
(12 cm) in diameter. The thickness of the lid can be
between .25" (6.3 mm) and 1" (2.54 cm).
Data Wires
Transmitter
2 Ejot
M4x14 Screws
+ 2 SST
W
ashers
Pit Lid
Spring Washer
Top
Protective
Cover
Nut
Bracket
Figure 6
Pit Installation