User's Manual

Installation
13
3. Connect the transmitter wires to the meter wires, using
gel cups (not supplied) to seal the connection. Use a
3M™ recommended tool to squeeze the gel cup until
the connection is sealed.
- If the meter wires are floating, connect the two data
wires to the meter wires.
- If one of the meter wires is connected to the
ground/common (-), connect it to the black wire on the
transmitter and connect the green wire to the switch
(+).
The transmitter wires are 18" (45.7 cm) long. If this is
not adequate to reach the meter, add up to 100 ft (30
m) of AWG20 wire.
!
C a u t i o n
To ensure that moisture does not damage the
transmitter, gel cups must be used to seal the
connection between the data wires and the
meter.
!
C a u t i o n
Make sure that the antenna is pointing
downwards in as straight a line as possible. If
necessary, bend the antenna into a vertical
position.