User's Manual

Installation
12
The AMR transmitter can be installed on the wall using
screws. Before installing, verify that there is sufficient
space around the transmitter. Allow 6.3" (16 cm) from the
bottom of the transmitter for the antenna.
The AMR transmitter can be mounted on the wall using
screws, as shown in Figure 5 below.
1. Position the AMR transmitter as high as possible on
the wall.
2. Secure with two stainless steel self-tapping screws
(ST4.2, pan head) and two stainless steel flat washers,
inner diameter: 0.17", outer diameter 3/8", thickness
0.032" (not supplied).
Data
W
ires
A
ntenna
W
ire
Transmitter
Flat
Washers
Tapping
Screws
Figure 5
Installation of AMR Transmitter – Wall Screw Mount