User's Manual

Installation
7
MAGNET
Figure 3
Enabling the AMR Transmitter
3. When the magnet is removed, the transmitter is
enabled and a transmission will be sent.
IMPORTANT: If the magnet is held near the unit for
more than ten seconds, wait another 30 seconds before
once again placing the magnet near the top of the
transmitter to enable it.
4. To view this transmission from the concentrator which
was configured to receive from this transmitter,
connect a notepad or laptop computer to the
concentrator (RS232 cable from COM port to RS232
port on MOSCAD/MOSCAD-L concentrator) and
open the Viewer tool. (See AMR FIU and
Concentrator Applications User Guide.) Look for the
transmitter ID and timestamp.
5. To view this transmission from the Host computer (in
the Central), use the Host application. (See the
documentation of the relevant Host application.) Look
for the transmitter ID and timestamp.