User's Manual

Installation
6
Changing the Transmitter Parameters
The AMR RF transmitter is configured in the factory. If
this configuration needs to be modified, use the AMR
ToolBox to change the parameters, as necessary. For more
information, see Appendix C below and the AMR
ToolBox User Guide.
Enabling the Transmitter
!
C a u t i o n
The AMR RF transmitter should be enabled
before mounting and installation. Do not
enable the AMR RF transmitter if it is to be
transported by air.
The AMR RF transmitter can be enabled with or without
the AMR ToolBox.
Without the AMR ToolBox
The transmitter can be enabled and tested without the
AMR ToolBox.
1. Short-circuit the two input wires by connecting the two
exposed wire endings.
2. Place a magnet (such as the one supplied with the
AMR Programming Kit) near the top of the housing as
shown in Figure 3 below for at least three (and no
more than five) seconds.