Installation Guide
Table Of Contents
- MOSCAD-M Remote Terminal Unit
- CONTENTS
- INTRODUCTION
- INSTALLATION
- THE MOSCAD˚M UNIT
- POWER MANAGEMENT
- ETHERNET INTERFACE OPTION
- APPENDIX A: CABLES AND ADAPTERS
- APPENDIX B: MODELS AND ACCESSORIES
- APPENDIX C: CHANGING THE ANALOG INPUT MEASUREMENT TYPE
Appendix C: Changing the Analog Input Measurement Type
49
Reassembling the RTU
Install Expansion Board
With the jumpers facing down and the 10-pin connectors on your right, lower the bottom of
the Expansion board into the case. Align the peg on the upper left-hand side of the board (A)
and the two tongues toward the bottom of the board (A) with the matching grooves (A) (see
Figure 28). Press the Expansion board under the two large snaps at the bottom of the board
until you hear them click (B). Press the top of the Expansion board under the two small snaps
until you hear them click (C).
Figure 28
Installing Expansion Board